Showing posts with label Tutorials. Show all posts
Showing posts with label Tutorials. Show all posts

Monday, May 18, 2009

HOW TO USE THE SCALLOP EDGE PUNCH

HOW TO USE THE SCALLOP EDGE PUNCH



Line up your cardstock in the center of the punch. There are "tick" marks on the
punch. You can also line up using the silver scallop image on the base of punch--this
will show you what the scallops at the end will look like--do you want a whole
scallop at the ends, or a 1/2 scallop? Push down on lever to punch.

If you remove the cardstock, this is what the first punch will look like.

Place cardstock back in punch and slide to one side--matching the silver scallop
image on the base of the punch. If you need to, move again, line up again, & punch again.


Do the same thing in the other direction--matching the silver scallops on the base.


This is what it will look like after you have punched to both edges.

How To Use the Stamp a ma jig

How To Use the Stamp-a-ma-Jig

The Stamp-a-ma-Jig (SAMJ) is one of those accessories that once you use it, you will be "addicted" and use it all the time. It's easy once you get the hang of it--just follow these steps and you will be able to perfectly place stamped images exactly where you want them. These instructions show how to use with "2-step" images, however, it works great to place single images, such as "words," exactly where you want them!


Step 1: Stamp the 1st image where you want it on your cardstock--in this case, it's the "bold" part of the flower.

Step 2: Place the "clear plastic sheet" that comes with the SAMJ exactly in the corner of the SAMJ and then stamp the image you want to perfectly place also exactly in the corner of the plastic.

Step 3: Now place the plastic sheet over the image on your cardstock--place exactly where you want the stamped image to appear.

Step 4: Holding the plastic sheet in place, set the SAMJ so that the corners of the plastic sheet fit exactly into the corner--just like when you stamped the image on the sheet in step 2 above

.
Step 5: Carefully remove the plastic sheet, leaving the SAMJ in place.


Step 6: Stamp your image onto the cardstock--place the stamp exactly in the corner of the SAMJ, just like in step 2 above.

Image is perfectly placed where you want it!

Make sure to clean off the "plastic sheet" after each use so that you can use it over and over again!


HOW TO TIE A "FAKE" BOW

HOW TO TIE A "FAKE" BOW
I am "bow illiterate" and unable to tie a bow--that is why I love this "fake" one.

To begin, you need 2 holes, about 1/4" apart--the Stampin' Up! Double Rectangle
punch works great--if you don't have it, you can just punch 2 side-by-side holes with
a hand-held punch.

You will need about a 10" piece of ribbon (this is a little long, but easier to work with
and can be trimmed when done.


With the front side up, poke both ends of the ribbon through the holes to the back


On the back, criss cross the ribbon and fold each side of the ribbon to form a
loop and poke the loop through to the front


This is the front showing the 2 "loops"


On the back, criss cross the ribbon again, and poke the ends through the
holes to the front


Adjust and trim the ends for the look you want